180 | Appendix B: System management |
2In the PEM window, click Configure LAN.
3If you want to require a password for remote access, enter the password in the Enter New Password box and in the Verify New Password box.
Passwords can be from 1 to 16 characters long, using any ASCII character in the range
4From the LAN Access Mode list, select the remote access mode:
• | Full Access | A remote system can initiate a LAN connection |
|
| regardless of the state or health of the server. |
• | Restricted | A remote system can initiate a LAN connection, |
|
| but cannot perform control operations such as |
|
| power down, reset, or front panel NMI. |
• | Disabled | Remote systems are not allowed to initiate LAN |
|
| connections. |
5 In the IP Setup box, choose either:
• | DHCP | The IP address for the server is automatically |
|
| assigned by the DHCP (dynamic host control |
|
| protocol) server on the network. The Host, |
|
| Gateway, and Subnet Mask boxes in the dialog |
|
| are ignored. |
• | Static | Assign the IP address for the server using the |
|
| Host, Gateway, and Subnet Mask boxes in the |
|
| dialog. |
6If you chose Static IP Setup in the previous step, fill in the IP addressing boxes:
• | Host IP | The IP address of this server. |
| Address |
|
• | Gateway IP | The IP address of the router for this server. |
| Address |
|