Parker Products COMPAX-M /-S (L) manual Configuration

Configuration

Front plate operation (not available with COMPAX 1000SL)

8.2Configuration

8.2.1 Front plate operation (not available with COMPAX 1000SL)

Unit	hardware
Connector	assignment / cable

Querying status values and modifying the bus parameters.

Meaning of the bus parameters:

Acknowledging error messages

Using the COMPAX front plate, you can query particular status values and perform the most important bus settings. Also whenever an error occurs, COMPAX shows the error number on the display.

choice of operation

A modes B

		Enter	Enter
	call smaller	call higher	call smaller	call higher
	Status	Status	C-parameter	C-parameter
choose	number	number	number	number	choose
Status					number of
number					C-parameter
		Enter		Enter
	without	without	decrease	increase
status	function	function	value	value	change
indicator					C-parameter
		Enter		Enter
		A		B

The following status values can be displayed via the front plate:

S03-S08, S11, S19-S26 (hexadecimal display), S27, S30, S31, S37-S39 (description of the status values: see Page 207).

The remaining status values can be queried via the interfaces.

C parameters			COMPAX parameters			Meaning		Valid from
C01				P194		Address of unit		Power on
C02				P195		Baud rate:		Power on
C03				P196		Bus protocol		Power on
C11				P250		HEDA address		immediately
C04 - C10						reserved
Display	Baud rate			Display	Baud rate		Display		Baud rate [Baud]
value		[Baud]		value	[Baud]		value
0		600		31	31 250		172		172 800
1		1200		38	38 400		187		187 500
2		2400		50	50 000		250		250 000
4		4800		57	57 600		345		345 600
9		9600		62	62 500		375		375 000
10		10 000		76	76 800		500		500 000
19		19 200		100	100 000		800		800 000
20		20 000		115	115 200		999		1 000 000
28		28 800		125	125 000

Please see operating instructions for the bus option used for the relevant range of values and the precise setting options.

Once you have rectified the cause of the error, you can acknowledge the error by pressing the "Enter" key.

Technical data
Configuration
Positioning and	control functions
Optimization	functions
Interfaces
Accessories /	options
Status
Parameter
list

71

Error