Parker Products COMPAX-M /-S (L) Compax 25XXS unit characteristics, Wiring up motor, Motor side

COMPAX 25XXS unit characteristics

COMPAX 25XXS connector and connection assignment

Before wiring up, always de-energize the unit.

Even once the mains supply has been switched off, dangerous levels of voltage can remain in the system for up to 5 min.

When working with motors without a holding brake, the brake lines must not be connected to COMPAX

The PE connection occurs with 10mm2 under a fixing bolt

Caution!

If the unit has no control voltage, no displays will indicate that operating voltage is present.

Wiring up motor On unit side

sheetshielding of motor cable

Unit	hardware
Connector	assignment / cable
Technical data
Configuration
and	functions

X5 RS485 IN

X7 RS485

OUT

AC

X2 supply

F19 3.16 AT

X3	24V DC
	supply
X1	motor and
	motor brake

AC	L3	230Vmax.AC +10% linetolinevoltage
L1	L2
230V	AC230V
C
AV
032
3 x 230V AC	1 x 230V AC
PE		PE
L3		N
L2			X1
L1		L

-

+

-

+

PE

W

V

U

connection for external contact for brake control

black 5

-

black 4 brake green/yellow+

PE black 3

W

Positioning	control
Optimization	functions

X4 braking resistance

PE

B-

B+

black 2

black 1

V U

Interfaces

Wiring up mains power / control voltage

!Note the screened connection of the motor cable on the upper side of the unit.

!Clamp the motor cable with the open section of the screen braid under the ground terminal.

Motor side

!Via connectors.

The mains supply and control voltage supply are located on the upper side of the unit.

Power supply: there are 2 options (with the same output power):

3 * 80V AC - 3 * 250V AC • 45-65Hz • fuse protection: 10A

1 * 100V AC - 1 * 250V AC • 45-65Hz • Fuse protection: 16A

!Layout of contactors for the power supply:

Capacity according to device performanc: Application group AC3.

Accessories / options

Status

Parameter

list

31

Error