Parker Products COMPAX-M /-S (L) manual Remarks regarding the structural diagram

Operating Instructions COMPAX-M / -S

Digital inputs and outputs

Logical inputs *

I1...I8

Field bus I17...I24

Logical inputs *

I9...I16

COMPAX–command

I41...I48

(OTA41...OTA48)

Field bus I25...I32

="0"

P221

="1"

logical I1...I8

≥1

="0"

logical

I9...I16P222 ="1"

logical I9...I16

COMPAX - control functions

(for P221=”0” corresponds to arrangement of inputs I1 to I8)

SHIFT, Hand+, Hand-, Quit, Start, Stop, approach Mn, approach RN, Tech RN

COMPAX – control functions

Depends on COMPAX device variants (for P222=”0” corresponds to arrangement of inputsIE9 to I16)

Structural diagram: Access to COMPAX control functions via inputs

*The logic inputs I1 ... I16 are, excluding COMPAX 1000SL, also the physical inputs I1 ...I16 on connectors X8 and X10.

With COMPAX 1000SL, the 8 physical inputs on connector X19 are allocated (via parameters P156

... P158) to 8 logic inputs from the range I1 ... I16 (see Page 140)

Remarks regarding the structural diagram

♦The control functions corresponding to I1.. I8 cannot be activated via OT O33...OT O40.

♦The control functions corresponding to I9...I16 can be activated simultaneously via the physical inputs and via OT O41...OT O48.

♦The enable input I12 (in COMPAX 1000SL, COMPAX XX70 and COMPAX XX30) must also be activated when allocated to the fieldbus (via P222).

Interrogation of inputs in the COMPAX program (IF I ..)

All inputs can be interrogated independently of parameters P221 and P222 in the COMPAX program with IF I... .

The virtual inputs I33...I48 in the COMPAX program can also be set via the commands OT O33...OT O48.

Logical inputs *

I1...I8

Logical inputs *

I9...I16

Field bus I17...I24

Field bus I25...I32

COMPAX–command I33...I40 (OTA33...OTA40)

COMPAX–command I41...I48 (OTA41...OTA48)

COMPAX – program

Interrogation of inputs with IF I1=

To

IF I48=

Regardless of parameters P221 and P222

With P233=48 (or P234=48), virtual inputs I48 – I25 are written to the optimization display status S13 (S14). Meaning: I25 = bit 0 ... I48 = bit 23.

146