Parker Products COMPAX-M /-S (L) COMPAX-M dimensions/installation, Compax 02XXM, NMD10, NMD20

Start-up manual COMPAX-M / -S

7.2.3 COMPAX-M dimensions/installation

The specific design of the COMPAX-M controller allows for wall installation (distance: 61mm in COMPAX P1XXM and 86mm in larger units) in two different ways.

Direct	Direct wall installation and dimensions of COMPAX-M and the mains
wall installation:	modules.	02XXM, 05XXM,				P1XXM
		15XXM, NMD10
				& NMD20			390
			85			60	340
				75		49
		50
	10	40			10	40

65 96

COMPAX-M COMPAX-M

450	430	364	450	430	364
		31			65
			50

Attach with four 6-mm	Attach with two 6-mm
hex-socket-head-screws	hex-socket-head-screws

The controllers are attached to the mounting plate with the back of the heat sink.

Indirect	Indirect wall installation of COMPAX 02XXM, COMPAX 05XXM and COMPAX
wall installation:	15XXM and the mains modules NMD10 and NMD20.

85

50

COMPAX-M

294

244 96

mounting plate

82

50

441,5

424

424 408

Fan configuration

50 50

mounting plate

The heat sink is pushed back through a hole in the panel (on right of diagram). A separate heat chamber is created between the installation plate and the rear wall of the control cabinet. The angles required under designation MTS2 must be complied with.

Indirect wall installation is not possible with COMPAX P1XXM.

Units with fan:	COMPAX P1XXM, COMPAX 05XXM, COMPAX 15XXM
Units without fan:	COMPAX 02XXM, NMD10, NMD20

20