Parker Products COMPAX-M /-S (L) manual Wiring up mains, Power / control, Module

COMPAX-M unit features

Unit hardware

Wiring up the motor

COMPAX-M system network, NMD10 / NMD20 mains module

Unit side
	U	V W PE			brake
cable conduit					PE	+	-
	black 1	black 2	black 3	green/ yellow	free	black 4	black 5
CO M PA X- M	CO M PA X- M
	1	2		3		4	5
	X1
	L1 L2L3 PE 24V			U V W PE brake
	+ -				PE+ -
	X1		X1
	PE
	X2		X2
	+LS
	-LS

24V	+X3	X3
	-

Connector assignment / cable

Technical data

Configuration

X4 X5 X4

Screened	Note the screened connection of the motor cable on the
connection	upper unit side.

Clamp the motor cable with the open place of the screen braid under the ground terminal (see figure on the right).

Only wire up brake in motors which have a holding brake! If not, do not wire.

Wiring up mains	The mains supply and the control voltage supply are provided by the mains
power / control	module.
voltage	Power supply:		Control voltage
	! 3*80V AC – max. 3*500V AC; 45 - 65Hz		! 24V DC ± 10%
	! Fuse protection:		Ripple <1VSS
	NMD10: 16A (K circuit breaker in 20A)		Fuse protection: max. 16A
	NMD20: 35A
	K circuit breaker or similar Neozed
	fusible cut-out.
	cable conduit	L1 L2 L3 PE 24V

+ -

	HAUSER	COMPAX-M	1	2	3	4	5
	COMPAX-M
			X1
SUPPLY	CO MPAX -M
			L1 L2L3 PE 24V			U	V W PE brake
				+ -			PE + -
			X1			X1
			PE
			X2			X2
		+LS

-LS

	+
24V	- X3	X3

power supply module

X4 X5 X4

19

Positioning and	control functions
Optimization	functions
Interfaces
Accessories /	options
Status
Parameter
Error list