Parker Products COMPAX-M /-S (L) Compax 1000SL Unit characteristics, PE terminal, LED display

Start-up manual COMPAX-M / S

7.7COMPAX 1000SL Unit characteristics

7.7.1 Connector and terminal assignment for COMPAX 1000SL

	H1	H2
	X6	X17
X6 RS232	RS232	Limit Switch	24 V DC
X17
initiators	X5	X7
bus	Fieldbus In	Fieldbus Out
systems:			R Dump
X5 IN
X7 OUT	X13	X12
X13
encoder	Encoder	Resolver
X12
resolver
X19 in-/	X19
output	COMPAX - SL
		Input / Output

							X3 24V DC
							supply
X3						X15
Input + -						HEDA In
							X14/X15	(Option)
							HEDA
						X14
X4						Out
		PE				HEDA
	-
	+						X4 ballast
X1					Brake		resistance
			+ -				X1 motor /
				PE			motor brake
				V W	Motor

U

X2

PE	AC
N	V
L1	230	X2 230V AC
		supply
		PE -
		connection

Before wiring up, always de-energize the unit.

Even once the mains supply has been switched off, dangerous levels of voltage can remain in the system for up to 5 min.

When working with motors without a holding brake, the brake lines must not be connected to COMPAX

Caution!

If the unit has no control voltage, displays will not indicate if operating voltage is present.

PE – terminal:	at least 2.5mm2
LED display	The following statuses are shown by the LEDs.
	Status	Red LED (H2)	Green LED (H1)
	24V not available	off	off
	24V are switched on, boot up	on	off
	Unit OFF	off	blinking
	Unit error; drive switched off	on	blinking
	Unit error; drive powered	on	on
	Unit RUNNING	off	on

40