Parker Products COMPAX-M /-S (L) Switch-on status, Configuration when supplied, Commissioning

Switch-on status COMPAX-M / -S

5. Switch-on status

5.1Configuration when supplied

When supplied, COMPAX is not configured. Parameter P149 is set to "0": P149="0": COMPAX is not configured and switches to OFF mode when switched

on (24V DC and operating voltage) (motor switched off). In addition to this, when switched on, all parameters (apart from bus settings P194, P195, P196 and P250) are set to their default values.

P149="1": COMPAX is configured and once switched on (24V DC and operating voltage) tries to engage the motor.

5.2Commissioning

Meaning of LEDs on the front panel

COMPAX-M / -S

LED	Color	Meaning, when switched on
Ready	green	24V DC present and initialization complete
Error	red	COMPAX - Error (E1...E56) present or COMPAX is
		initialized.

Mains module

LED	LED	Possible errors
red	green
Error	Ready
off	on	no errors
on	off	Heat sink temperature too high or
		error in logic voltage (24V DC too low or unit is defective)
		Emergency stop is activated and ready contact is
		released.
on	on	Ballast switching unit overload or
		undervoltage (<100V DC or <80V AC).

COMPAX 1000SL

Status	Red LED (H2)	Green LED (H1)
24V not available	off	off
24V are switched on, boot up	on	off
Unit OFF	off	blinking
Unit error; drive switched off	on	blinking
Unit error; drive powered	on	on
Unit RUNNING	off	on

Caution!

If there is no control voltage, no displays will appear to indicate that operating voltage is present.

Note: With Error E40, external enabling is missing with COMPAX 45XXS, COMPAX 85XXS and COMPAX 1000SL (Hardware input).

10