106

3 Hardware configuration

To install the foam fan baffle

1Position the fan baffle so the holes in the bottom of the baffle are aligned with the four hot swap drive bay mounting screws (or holes) in the front subchassis.

2Gently bend back the ends of the foam baffle (Figure 54, A), then push down and slide the baffle straight into the chassis until the tabs on the front subchassis mate with the corresponding notches in the baffle.

3Install the fan distribution board.

4Install the fan modules.

5Install the front access panel.

Page 122
Image 122
Acer G901 manual To install the foam fan baffle