84 | 3 Hardware configuration |
To install a power supply module
1If present, remove the filler panel from the vacant slot.
2Holding the power supply latch handle in the open position, slide the power supply module into the vacant slot until you feel resistance.
Caution! The module engaging its connector causes the resistance. To avoid damaging the module, do not tilt or twist the power supply module as you push it into the connector.
3Guide the power cord through the strain relief notch in the latch handle and plug the cord into the AC power connector on the back of the power supply module.
4Press the latch handle down to engage the latches and secure the power supply to the chassis.
5Insert and tighten the four screws that secure the power supply module to the chassis.
6Connect the AC power cord to the wall outlet or other AC power source.
The green LED on the power supply module should be illuminated.
