Advantech 5000 Series user manual $aaSiER, Name Initialize Eeprom data

Command Set		5017/5018
		Analog Input
$aaSiER
Name	Initialize EEPROM data

Description Initializes all EEPROM data in a specified analog input module to their default values. This command is sent following a failed attempt to calibrate a module (the module shows no effect from an attempted calibration). Following initialization, the problem module should readily accept calibration.

Syntax	$aaSiER(cr)
	$ is a delimiter character.
	aa (range 00-FF) represents the 2-character hexadecimal
	address of the ADAM-5000 system.
	Si identifies the I/O slot for which you wish to initialize
	all EEPROM data.
	ER is Initialize all EEPROM data command.
	(cr) is the terminating character, carriage return (0Dh)
Response	!aa(cr) if the command is valid.
	?aa(cr) if an invalid operation was entered.
	There is no response if the module detects a syntax error
	or communication error or if the specified address does
	not exist.
	! delimiter character indicating a valid command was
	received.
	? delimiter character indicating the command was
	invalid.

aa(range 00-FF) represents the 2-character hexadecimal

address of an	ADAM-5000 system.
(cr) is the terminating character, carriage return (0Dh)
6-50	ADAM-5000