Advantech 5000 Series user manual Syntax $aaSiERcr

Chapter 6

$aaSiER

Name	Initialize EEPROM Data
Description Initializes all EEPROM data in a specified analog input
	module to their default values. This command is sent
	following a failed attempt to calibrate a module (the
	module shows no effect from an attempted calibration).
	Following initialization, the problem module should
	readily accept calibration.
Syntax	$aaSiER(cr)
	$ is a delimiter character.
	aa (range 00-FF) represents the 2-character hexadecimal
	address of the ADAM-5000 system.
	Si identifies the I/O slot in which you wish to initialize all
	EEPROM data.
	ER represents the initialize EEPROM data command.
	(cr) is the terminating character, carriage return (0Dh)
Response	!aa(cr) if the command is valid.
	?aa(cr) if an invalid operation was entered.
	There is no response if the module detects a syntax error
	or communication error or if the specified address does
	not exist.
	! delimiter character indicating a valid command was
	received.
	? delimiter character indicating the command was
	invalid.
	aa (range 00-FF) represents the 2-character hexadecimal
	address of an ADAM-5000 system.
	(cr) is the terminating character, carriage return (0Dh)
ADAM-5000	6-29