Command Set | 5024 Analog Output | |
|
|
|
$aaSiCj3hh
(cr) is the terminating character, carriage return (0Dh)
Example command: $07S1C2314(cr)
response: !07(cr)
The command tells channel 2 of the analog output module in slot 1 of the
The analog output module confirms the increase.
Note: In order to perform a Trim Calibration, either a mA meter or a resistor and voltmeter should be connect- ed to the module's output prior to calibration. (See also the 4 mA and 20 mA Calibration commands of the analog output module's command set. Refer also to Chapter 4, Section 4.5, Analog Output Calibration for a detailed description.)