
Command Set
6.1Introduction
To avoid communication conflicts when several devices try to send data at the same time, all actions are instigated by the host computer. The basic form is a command/response protocol with the host initiat- ing the sequence.
When systems are not transmitting they are in listen mode. The host issues a command to a system with a specified address and waits a certain amount of time for the system to respond. If no response arrives, a
6.2Syntax
Command Syntax: [delimiter character][address][slot][channel] [command][data][checksum][carriage return]
Every command begins with a delimiter character. There are four valid characters: $, #, % and @.
The delimiter character is followed by a two character address (hexa- decimal) that specifies the target system. The two characters following the address specify the module slot and channel.
Depending on the command, an optional data segment may follow the command string. An optional two character checksum may also be appended to the command string. Every command is terminated with a carriage return (cr).
Note: All commands should be issued in UPPERCASE characters only!