AMX Wireless Touch Panels (Wave Server) instruction manual Wireless status optional SMT-PK

Note

This SMT-PK page provides read-only information about the Smart Pack. The only setting that can be changed is the SLEEP TIMEOUT value.

from left to right as the RF signal intensity increases. The shaded area fluctuates between 0% and 100%.

Wireless status (optional SMT-PK)

The WIRELESS STATUS button appears on the Setup page when a SmartPack is connected to the touch panel. Press the WIRELESS STATUS button to open the optional page shown in Figure 91.

Figure 90

SMT-PKM page

Refer to the SmartPacks for TiltScreen Touch Panels instruction manual for detailed information. The SmartPack page shows the following information:

•SLEEP TIMEOUT Press the UP and DN buttons to set the time-out. The minimum time-out is 1 minute and maximum is 120 minutes. When the panel goes to sleep, all communication and battery discharge stops. If the time-out is set to 5, the panel goes into sleep mode if there is no activity for 5 minutes. The panel wakes up when you touch the screen.

•	Smart-Pak Not Locked/Locked Appears when an optional SMT-PK is
	connected to the panel. Not locked indicates the panel is not communicating
	with the AXR-RF RF receiver. Locked indicates the panel is locked on to the
	AXR-RF connected to the Central Controller.
•	Battery Voltage XX.X Shows the voltage level of the lead-acid
	rechargeable battery in the SMT-PK.

66 Touch Panel Program Reference ViewPoint Wireless Touch Panels