AMX Wireless Touch Panels (Wave Server) instruction manual Wireless settings for VPT-CP and VPT-GS

Note

Refer to the Wireless status (optional WAV-PK) subsection for information on how to set the RF and IR.

Figure 91

WIRELESS SETTINGS page (VPT-CP and VPT-GS)

•Module Version vX.XX Shows the firmware version installed in the SMT-PK.

• Fully Charged/Not Charging/Charging Fully Charged appears when

the battery in the SMT-PK is fully charged. Not Charging appears when the lead-acid battery is not charging. Charging appears when the lead-acid battery is charging. The shaded area is a horizontal gauge moving from left to right as the battery voltage level increases.

•AMX RF ON/OFF Shows RF transmission on or off.

•Supply Voltage vX.XX Shows the voltage level of the external power supply (optional) connected to the SMT-PK.

•AMX IR 38 kHz/455 kHz/OFF Shows the IR transmitting frequency to 38 kHz, 455 kHz, or OFF.

Wireless settings for VPT-CP and VPT-GS

The WIRELESS SETTINGS button appears on the Setup page. The VPT-CP and VPT- GS provide one-way touch panel control, and transmits RF and high or low- frequency IR signals. The ViewPoint contains a Nickel Metal Hydride rechargeable battery that supplies independent power to the touch panel. Press the WIRELESS SETTINGS button to open the page shown in Figure 91.

•SLEEP TIMEOUT Press the UP and DN buttons to set the sleep time. The minimum sleep time is 0 (off) and maximum is 120 minutes. When the touch panel goes to sleep, all communication and battery discharge stops. If the sleep time is set to 5, the panel goes into sleep mode if there is no activity for

ViewPoint Wireless Touch Panels Touch Panel Program Reference 67