AMX Wireless Touch Panels (Wave Server) instruction manual Button Properties page for Joysticks

Figure 57

Button Properties page for Joysticks

Note

If you followed the instructions for Adding a joystick to a page subsection, this button's Properties page appears.

Note

If DEVICE USED is set to 4 and Base Device Number is 128, the Central Controller recognizes bus devices 128, 129, 130, and 131.

Figure 58

CHANNEL code buttons

Note

The panel will not allow you to enter a device number greater than the DEVICE USED without first displaying a decision box. This box asks you to decide whether you accept the new selection or default to the previous value.

Note

The channel code for non- active buttons is 0 and for active buttons is 1 through 255.

Setting the channel code

The channel buttons that set the device and button channel codes for the touch panels are shown in Figure 58.

1.Press DEV to open a keypad and set the joystick’s device number.

2.Enter 1, 2, 3, or 4 in the keypad. The device number specifies the device number that the selected channel’s feedback displays.

3.Press ENTER to store the device number into memory, close the keypad, and return to the Button Properties page.

4.Press CHAN to open the keypad and enter a channel value of 1 through 255 in the keypad. The AXCESS software program uses the channel code number to identify the button and its’ programmed operations.

5.Press ENTER to store the channel number in memory, close the keypad, and return to the Button Properties page.

46 Designing Touch Panel Pages ViewPoint Wireless Touch Panels