Figure 209
Buttons string commands
Buttons string commands
CommandDescription
Note
At present, VGA and video are not supported by the ViewPoint.
"'$ID<group ID>'"
"'$SL'"
"'#ST<sleep time>'"
Set the
<group ID > = 0 (off) - 15
Example:
$ID15
Sets the touch panel button group ID to 15.
Activate sleep mode on the touch panel.
Example:
$SL
Activates sleep mode on the touch panel.
Set the idle time to activate sleep mode for a touch panel in
<sleep time> = 0 (off) - 120 minutes
Example:
#ST5
Sets the touch panel’s sleep time to 5 minutes.
Button Macro Commands
Only one macro can run at a time and the panel will be "locked" for the duration of the macro. A message will appear in the center of the touch panel signifying that a macro is executing and will not disappear until the completion of the macro. In addition, the touch panel must be pointed at the IR receivers during the entire macro execution cycle. Otherwise, some transmitted IR signals from the touch panel may not reach the receiver.
An unsupported feature, at this time, is the mixture of other strings within IR macro string blocks. However, other string types may occur before and after the macro blocks as long as the strings are separated from the macro block with a <CR> and the macro command exists at the beginning of the line.
The two commands are identified and defined in Figure 210.
158 | AXCESS Programming | ViewPoint Wireless Touch Panels |
