BIOS CONFIGURATION
When you choose this option, the physical disks connected to the SATA RAID controller are listed. Move the cursor to the de- sired drive and press Enter to view drive information.
3.7.4.2 Create Pass-Through Disk
Controller I/O Port:F3000000h, F2: Select Controller, F10: Reboot System
Areca Technology Corporation RAID Controller
Main Menu | | | | |
Quick Volume/Raid Setup | | | |
Physical Drive Information | | |
Raid Set Function | | | |
Volume Set Function | | | |
View Drive Information | | | |
| PassSelect-ThroughThe DriveDisk Attribute | |
Physical Drive Information | | Create Pass-Through |
Create Pass-Throught | |
Raid System Function | : 0 | |
Modify | SCSI Channel | Yes |
Ethernet | | | |
Delete Pass-Through Disk | 0 | |
| SCSICh04ID 80.0GB: | No |
View System Ev nts | : | 0 |
Identify SelectedSCSI LUNDrive | |
Clear Event Buffer | : Write Back | |
| Cache Mode | |
Hardware Monitor | : Enabled | |
| Tag Queuing | |
System information | | | |
ArrowKey Or AZ:Move Cursor, Enter: Select, ESC: Escape, L:Line Draw, X: Redraw
A Pass-Through Disk is not controlled by the SATA RAID con- troller firmware and thus cannot be a part of a volume set. The disk is available directly to the operating system as an individual disk. It is typically used on a system where the operating sys- tem is on a disk not controlled by the SATA RAID controller firm- ware. The SCSI Channel, SCSI ID, SCSI LUN, Cache Mode, and Tag Queuing must be specified to create a pass-through disk.
3.7.4.3 Modify a Pass-Through Disk
Use this option to modify Pass-Through Disk Attributes. To select and modify a Pass-Through Disk from the pool of Pass-Through Disks, move the cursor bar to the “Physical Drive Function” menu and select the “Modify Pass-Through Drive” option and then press the Enter key. The “Physical Drive Function” menu will show all Raid Pass-Through Drive number options. Move the cursor bar to the desired item and then press the Enter key
to show all Pass-Through Disk Attributes. Select the parameter from the list to be changed and them press the Enter key to modify it.
