
AutoDome 800 Series HD PTZ Camera | Configuring the AutoDome 800 Series en 111 |
|
|
Posting interval
Enter the interval in seconds at which the images will be sent to an FTP server. Enter zero if you do not want any images to be sent.
FTP server IP address
Enter the IP address of the FTP server on which you wish to save the JPEG images.
FTP server login
Enter your login name for the FTP server.
FTP server password
Enter the password that gives you access to the FTP server.
Path on FTP server
Enter the exact path on which you wish to post the images on the FTP server.
Max. Bit Rate
Enter the maximum bit rate for the JPEG images.
7.53IPv4 Filter
Use this setting to configure a filter that allows or blocks network traffic that matches a specified address or protocol.
IP Address 1 / 2
Enter the IPv4 address that you want to allow or block
Mask 1 / 2
Enter the subnet mask for the appropriate IPv4 address.
7.54Encryption
A special license, with which you will receive a corresponding activation key, is required to encrypt user data. You can enter the activation key to release the function on the Licenses page (see Section 7.57 Licenses, page 112).
7.55Advanced Mode: Service
7.56Maintenance
Firmware
The AutoDome 800 Series is designed in such a way that its functions and parameters can be updated with firmware. To do this, transfer the current firmware package to the unit via the selected network. It will then be automatically installed there.
In this way, an AutoDome 800 Series can be serviced and updated remotely without a technician having to change the installation on site.
Refer to Section 9 BVIP Firmware Updates, page 115, for firmware upgrade instructions.
Bosch Security Systems, Inc. | Installation Manual | F.01U.273.797 5.0 2012.08 |