58 en Using the AutoDome 800 Series | AutoDome 800 Series HD PTZ Camera |
|
|
Figure 6.1 AutoDome 800 Series System Configuration
1AutoDome 800 Series
2 IP Connection
3 Network Switch
4 Computer
NOTICE!
You can also use the Bosch Configuration Manager utility to configure the network settings for an AutoDome 800 Series camera. Go to www.boschsecurity.com to download the Configuration Manager software (part of the BVIP Lite Suite) and Operating Manual.
6.4 | Configuring the AutoDome 800 Series Camera |
To operate the camera in your network you must assign it a valid network IP address. The default IP address is 192.168.0.1, but you may have to change this address if it conflicts with another device on your network. Refer to Section 7.3 Basic Mode: Network, page 72 for more information.
To properly configure the camera for your network, you need the following information:
–Unit IP address: An identifier for the camera on a TCP/IP network. For example, 140.10.2.110 is a valid syntax for an IP address.
–Subnet mask: A mask used to determine what subnet an IP address belongs to.
–Gateway IP address: A node on a network that serves as an entrance to another network.
–Port: An endpoint to a logical connection in TCP/IP and UDP networks. The port number identifies the use of the port for use through a firewall connection.
NOTICE!
Ensure that the network parameters of your cameras are available before you begin configuration.
The AutoDome 800 Series defaults are as follows:
–IP Address: 192.168.0.1
–Subnet Mask: 255.255.255.0
–Gateway IP Address: 0.0.0.0
The following sections provide instructions about installing the software necessary to view images over an IP connection, configuring the IP network settings and accessing the AutoDome 800 Series images from a Web browser.
F.01U.273.797 5.0 2012.08 | Installation Manual | Bosch Security Systems, Inc. |
