AutoDome 800 Series HD PTZ Camera

Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts en 23

 

 

1.Compress the bottom hinge pin by pushing the pin lever downward and rotating it behind the Hinge Pin Stop.

Figure 2.9 Pendant Arm to Power Box Hinge Alignment

2.Open the top hinge by pushing its pin lever up and holding it.

NOTICE! Both Hinge Pins must be fully compressed to open (unlock) the hinges of the

Pendant Arm and before proceeding to the next step.

3. While continuing to hold the top hinge pin open and align the top and bottom hinges of the Pendant Arm to their mating points on the Power Supply Box. See Figure 2.9, above, for an illustration.

4. Once you have the hinges aligned, release the top hinge pin to engage its mating hinge on the power box. Then release the bottom hinge pin from the Hinge Pin Stop to lock the Pendant Arm to the Power Supply Box.

WARNING!

Serious injury or death can occur if the hinge pins of the Pendant Arm are not fully engaged (locked) to the Power Supply Box. Exercise caution before releasing the Pendant Arm.

2.7Make Connections in Power Supply Box

Refer to Table 2.2, Page 21 to locate the various connectors in the power supply box and make the following connections detailed below.

Bosch Security Systems, Inc.

Installation Manual

F.01U.273.797 5.0 2012.08

Page 23
Image 23
Bosch Appliances VG5 800 SERIES 7Make Connections in Power Supply Box, Pendant Arm to Power Box Hinge Alignment