AutoDome 800 Series HD PTZ Camera

Installing Roof Parapet and Pipe Mounts en 43

 

 

Figure 3.6 Parapet Wall Mount Bracket and Roof Mount Plate

 

1

Pipearm

4

Apply sealant around each fastener hole

 

2

Parapet Wall Bracket

5

Roof Mount Plate

 

3

3/8-16 SS Hex Head Bolt (supplied)

6

Use a minimum of six (6) fasteners (not

 

 

 

 

supplied). Eight (8) fastener holes shown.

 

 

 

 

 

NOTICE! Fasteners are not supplied with the Roof Parapet Mount Kit since it depends on the material to which it is attached. The material must accommodate a minimum pull out strength of 275 kg (600 lbs). For example, 19 mm (3/4 inch) minimum for plywood. Fasteners can include bolts, studs, or lag bolts. All fasteners must be made of corrosion-resistant stainless steel, with a diameter of 10 mm (3/8 inch).

All bolts must fully extend through the mounting surface and be secured with a flat washer, lock washer and a nut. All studs must be anchored to concrete or welded to a steel backing plate. Anchor bolts can be used for blind structures where there is no access to the rear.

3.Apply a weatherproof sealant around each fastener hole at the mounting surface.

4.Attach the Parapet Wall Bracket using at least six (6) stainless steel fasteners, three (3) on each side (the bracket has eight (8) holes). Be careful not to over tighten the fasteners because it may strip the threads. If attaching the parapet mount to a flat roof, attach the optional LTC 9230/01 Roof Mount Plate to the roof and then attach the Parapet Wall Bracket to the Roof Mount Plate.

5.Insert the Parapet Pipe Arm into the mounting bracket until it bottoms in the bracket.

6.Remove the End Cap from the front of the arm and feed the video, control, and power wires up through the bottom of the pipe arm and out the front end.

Bosch Security Systems, Inc.

Installation Manual

F.01U.273.797 5.0 2012.08

Page 43
Image 43
Bosch Appliances VG5 800 SERIES installation manual Parapet Wall Mount Bracket and Roof Mount Plate