AutoDome 800 Series HD PTZ CameraInstalling the Pendant Arm Wall, Corner, and Mast (Pole) Mounts en 31

2.9

Attach Pendant to Arm and Tighten

CAUTION!

The bubble is packaged with a protective plastic sheet. It is recommended that the bubble remain stored this way until it is ready to install. Limit handling the bubble, as any scratches can quickly affect visibility.

NOTICE! Before attaching the AutoDome Pendant, visually inspect the dome and arm connectors for any blocked pin holes or bent pins.

1.Tilt the bottom of the dome toward the pendant arm base and place the mounting hook, located on top of the dome housing, over the recessed hinge pin of the arm.

a

b

Figure 2.15 Attach Pendant to Arm

1

Tilt up.

2

Hook and drop.

2a

Recessed Hinge Pin

2b

Dome Connector

3

Rotate down to engage dome connector.

4

Tighten the two (2) mounting screws to a minimum torque of 10-12 N-m (90-105 in.-lbs).

2.Drop the dome housing down slightly to engage the dome housing hook on the Pendant Arm hinge pin, allowing the dome to rotate around the pin.

3.Rotate the dome housing down to a vertical position and gently push upward to engage the connector on top of the dome housing.

Bosch Security Systems, Inc.

Installation Manual

F.01U.273.797 5.0 2012.08

Page 31
Image 31
Bosch Appliances VG5 800 SERIES installation manual Attach Pendant to Arm and Tighten