AutoDome 800 Series HD PTZ Camera | Configuring the AutoDome 800 Series en 71 |
|
|
CAUTION!
Do not use any special characters, for example &, in the name.
Special characters are not supported by the system's internal recording management and may therefore result in the Player or Archive Player being unable to play back the recording.
Password
An AutoDome 800 Series is generally protected by a password to prevent unauthorized access to the unit. You can use different authorization levels to limit access.
The AutoDome 800 Series operates with three authorization levels: service, user and live. The highest authorization level is service. After entering the correct password, you can access all the functions of the AutoDome 800 Series and change all configuration settings.
With the user authorization level, you can operate the unit and also control cameras, for example, but you cannot change the configuration.
The lowest authorization level is live. It can only be used to view the live video image and switch between the different live image displays.
You can define and change a password for each authorization level if you are logged in as service or if the unit is not password protected.
Enter the password for the appropriate authorization level here.
NOTICE!
Proper password protection is only guaranteed when all higher authorization levels are also protected with a password. If a live password is assigned, for example, a service and a user password must also be set. When assigning passwords, you should therefore always start from the highest authorization level, service, and use different passwords.
Confirm password
In each case, enter the new password a second time to eliminate typing mistakes.
NOTICE!
A new password is only saved when you click the Set button. You should therefore click the Set button immediately after entering and confirming a password.
7.2 | Basic Mode: Date/Time |
Device date/Device time/Device time zone
If there are multiple devices operating in your system or network, it is important to synchronize their internal clocks. For example, it is only possible to identify and correctly evaluate simultaneous recordings when all units are operating on the same time. If necessary, you can synchronize the unit with your computer's system settings.
Click the Sync to PC button to copy your computer's system time to the AutoDome 800 Series.
Time server IP address
The AutoDome 800 Series can receive the time signal from a time server using various time server protocols, and then use it to set the internal clock. The unit polls the time signal automatically once every minute.
Enter the IP address of a time server here.
Time server type
Select the protocol that is supported by the selected time server. Preferably, you should select the SNTP server as the protocol. This supports a high level of accuracy and is required for special applications and subsequent function extensions.
Bosch Security Systems, Inc. | Installation Manual | F.01U.273.797 5.0 2012.08 |
