AutoDome 800 Series HD PTZ Camera

Configuring the AutoDome 800 Series en 81

 

 

DSL

Target bit rate: 400 kbps

Maximum bit rate: 500 kbps

Encoding interval: 30.00 ips

ISDN (2B)

Target bit rate: 80 kbps

Maximum bit rate: 100 kbps

Encoding interval: 30.00 ips

You can change individual parameter values of a profile and you can also change the name. You can switch between profiles by clicking the appropriate tabs.

CAUTION!

The profiles are rather complex. They include a large number of parameters that interact with one another, so it is generally best to use the default profiles.

Change the profiles only once you are fully familiar with all the configuration options. In the default setting, Stream 2 is transmitted for alarm connections and automatic connections. Bear this fact in mind when assigning the profile.

NOTICE!

All parameters combine to make up a profile and are dependent on one another. If you enter a setting that is outside the permitted range for a particular parameter, the nearest permitted value will be substituted when the settings are saved.

Profile name

You can enter a new name for the profile here. The name is then displayed in the list of available profiles in the Profile name field.

Target data rate

You can limit the data rate for the AutoDome 800 Series to optimize utilization of the bandwidth in your network. The target data rate should be set according to the desired picture quality for typical scenes with no excessive motion.

For complex images or frequent changes of image content due to frequent movements, this limit can be temporarily exceeded up to the value you enter in the Maximum data rate field.

Maximum data rate

This maximum data rate is not exceeded under any circumstances. Depending on the video quality settings for the I- and P-frames, this fact can result in individual images being skipped. The value entered here must be at least 10% higher than the value entered in the Target data rate field. If the value entered here is too low, it will automatically be adjusted.

Video resolution

Here you can select the desired resolution for the video image. The following resolutions are available for standard definition settings only:

QVGA 320×240 pixels

VGA

640 x 480 pixels

CIF

352 × 288/240 pixels

4CIF/D1

704 × 576/480 pixels

Bosch Security Systems, Inc.

Installation Manual

F.01U.273.797 5.0 2012.08

Page 81
Image 81
Bosch Appliances VG5 800 SERIES Profile name, Target data rate, Maximum data rate, Video resolution, 4CIF/D1