44 en Installing Roof Parapet and Pipe Mounts

AutoDome 800 Series HD PTZ Camera

 

 

Figure 3.7 VG4-A-9230 Parapet Mount

1

End Cap with O-ring

2

Parapet Pipe Arm

3

1/4-20 SS Cap Screw

4

Down Pipe

5

10-24 SS Pan Head Screw

7.Fold the Ethernet and power wires back at the front end of the arm and route them down and out through the Down Pipe. Then replace the End Cap.

8.Wrap at least five layers of Teflon tape around the Down Pipe threads.

9.Apply the supplied thread sealant to the Down Pipe threads:

Make sure all surfaces are clean and dry.

Apply a bead of sealant completely around the leading threads of the male fitting.

Force the adhesive into the threads to thoroughly fill all voids.

10.Thread the Dome Cap onto the down pipe and tighten securely. See the illustration below.

WARNING!

You must thread the Dome Cap onto the Down Pipe until it is tight. Failure to do so can result in damage, serious injury, or death.

Figure 3.8 Attach Dome Cap

1Thread Sealant or tape

2 Dome Cap

11.Run a bead of RTV Silicon sealant around the down pipe/Dome Cap interface to seal any gaps between the down pipe and the Dome Cap.

F.01U.273.797 5.0 2012.08

Installation Manual

Bosch Security Systems, Inc.

Page 44
Image 44
Bosch Appliances VG5 800 SERIES installation manual End Cap with O-ring