AutoDome 800 Series HD PTZ Camera

Installing Roof Parapet and Pipe Mounts en 45

 

 

12.Proceed to Section 3.7 Wire the Pipe Interface Board, page 46.

NOTICE! Use a guy-wire to aid in stabilizing the Parapet Arm. Replace the 1/4 inch cap screw with a threaded 1/4-inch stainless steel eye bolt (not supplied). Loop the guy-wire through the eye bolt and attach both ends to anchor spots on the roof. See Figure 3.7, Page 44.

3.6Installing the VG4-A-9543 Pipe Mount

This section details the installation steps for the VG4-A-9543 Pipe Mount. If you are installing the Roof Parapet mount, see Figure 3.7, Page 44, for instructions.

NOTICE! Customer must supply 1-1/2 inch (NPS) pipe threaded on both ends with a minimum length of 5 inches (12.7 cm).

5 in. min.

12.7 cm

Figure 3.9 Pipe Mount

1Gasket

2Flange

3 Cap

1.Before installing the Top-Mounting Flange, ensure there is an adequate opening in the ceiling or mounting structure for the wires to pass through.

2.Secure the pipe Flange with supplied gasket to the ceiling or other supporting structure using four (4) 10-mm (3/8-inch) diameter fasteners.

NOTICE! Each fastener must have a minimum pullout strength of 275 kg (600 lbs). The mounting material must be able to withstand this pull-out force. For example, 19-mm (3/4- inch) minimum for plywood.

3.Attach pipe (not supplied) to the Top-mounting Flange.

WARNING!

You must thread the pipe onto the Top-mounting Flange until it is tight. Failure to do so can result in damage, serious injury or death.

4.Route the power, Ethernet and alarm wires through the Top-Mounting Flange and down the pipe.

5.Wrap at least five layers of Teflon tape around the threads.

6.Apply the supplied thread sealant to the threads on the Pipe.

Make sure all surfaces are clean and dry.

Apply a bead of sealant completely around the leading threads of the male fitting.

Force the adhesive into the threads to thoroughly fill all voids.

Bosch Security Systems, Inc.

Installation Manual

F.01U.273.797 5.0 2012.08

Page 45
Image 45
Bosch Appliances VG5 800 SERIES installation manual 6Installing the VG4-A-9543 Pipe Mount