
AutoDome 800 Series HD PTZ Camera | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts en 25 |
|
|
6.Connect the
7.If installing a Fiber Optic model attach the incoming ST fiber plug, installed previously, to its mating connector on the Fiber Optic Module in the power supply box. Then attach the Ethernet cable to its mating connector from the Pendant Connector Harness. See Section 4 Cable and Wire Standards, page 51 for fiber optic specifications.
(GND) (FUSE)
24V NC 24V
GND TXD RXD | C+ | C- |
HTR DOME
(FUSE) (FUSE)
Figure 2.11 Optional Fiber Optic Module
1 | Transformer | 5 | In/Out |
2 | Ethernet to Dome | 6 | ST Connector (Fiber) |
3 | In/Out | 7 | Power In |
4 | From Arm Harness | 8 | Data In/Out |
8.Connect the incoming RJ45 connector, installed previously, to its mating connector from the Pendant Connector Harness. See Section 4 Cable and Wire Standards, page 51 for connections and specifications.
9.Attach the grounding strap of the Pendant Arm to the Power Supply Box. See Figure 2.10, Page 24.
10.After making the harness connections to the Power Supply Box, rotate the Pendant Arm to close and seal the Power Supply Box and tighten the two (2) captive screws to
11.Refer to Section 2.9 Attach Pendant to Arm and Tighten, page 31, to continue the AutoDome Installation procedure.
NOTICE! After all wiring is complete, close the cover door and tighten the two (2) captive screws on the cover door to
Bosch Security Systems, Inc. | Installation Manual | F.01U.273.797 5.0 2012.08 |