
16 en Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | AutoDome 800 Series HD PTZ Camera |
|
|
| CAUTION! |
| Select a rigid mounting location to prevent excessive vibration to the AutoDome camera. |
|
|
2.3 | Mount Power Supply Box |
| Before mounting the Power Supply Box decide if you should wire the box through the holes in |
the bottom or back of the box. If wiring the box through the back, move the two (2) seal plugs to the bottom through the holes before mounting.
NOTICE! Use
Figure 2.1 Power Supply Wall (with optional trim skirt), Mast (Pole), and Corner Mounts
1.Use the wall mount template supplied in the packaging box to locate the four mounting holes for the Power Supply Box.
2.Drill four (4) holes for the mounting anchors. If installing outdoors, apply a weatherproof sealant around each hole at the mounting surface.
WARNING!
A stud diameter of 6.4 mm (1/4 inch) to 8 mm (5/16 inch) able to withstand a 120 kg (265 lb)
3.Place the Power Supply Box into the optional Trim Skirt.
4.Secure the Power Supply Box to the mounting surface.
–For a Wall installation: Use four (4)
–For a Corner installation: Secure the Corner Plate to the wall corner using four (4) studs (not included). Then proceed to Step 5 below.
–For a Mast or a pole installation: The metal straps included with the Mast mount accommodate a pole with a diameter of
5.Secure the Power Supply Box to the Corner Plate or Mast Plate using the four (4) 3/8 x 1-
F.01U.273.797 5.0 2012.08 | Installation Manual | Bosch Security Systems, Inc. |