AutoDome 800 Series HD PTZ Camera

Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts en 29

 

 

Figure 2.14 Mounting Plate - Inside Detail

Ref. Description

1Grounding lug with two spade terminals

2 Earth ground lug with crimp ring terminal

3 Wire input conduit holes

4.Connect the incoming 24 VAC power wires to the 5-pin, 24 VAC Power In mating connector (supplied with the Mounting Plate kit) for the Dome and for the Heater.

5.Attach the grounding spade from the 5-pin mating connector (item 1, Figure 2.14) to the other spade terminal inside the mounting plate.

6.Attach the 5-pin Power In mating connector to the 24 VAC Power cable (cable 2) connected to the pendant.

7.Connect the incoming RJ45 video connector, installed previously, to the Ethernet cable (cable 5). Refer to Section 4 Cable and Wire Standards, page 51, for detailed wire and connection information.

8.Connect the outgoing alarm wires to the flying leads coming from the 4-pin Alarm Outputs cable (cable 6).

9.Connect the incoming alarms wires to the flying leads coming from the 6-pin Alarm Inputs cable (cable 7).

10.Connect the incoming Audio In wires to the 6-pin mating connector supplied with the VG4-A-ARMPLATE kit. Ensure that the 100 Ω resistor has been removed between C- (Audio -) and the C+ (Audio +) terminals.

Refer to Section 4 Cable and Wire Standards, page 51, for detailed wire and connection information.

11.Attach the 6-pin Audio In mating connector to the Audio In (cable 8) cable.

Bosch Security Systems, Inc.

Installation Manual

F.01U.273.797 5.0 2012.08

Page 29
Image 29
Bosch Appliances VG5 800 SERIES installation manual Ref. Description, Mounting Plate Inside Detail