
AutoDome 800 Series HD PTZ Camera | Configuring the AutoDome 800 Series en 93 |
|
|
Standard recording
Here you can select the mode for standard recordings.
If you select Continuous, the recording proceeds continuously. If the maximum memory capacity is reached, older recordings will automatically be overwritten. If you select the Pre- alarm option, recording will only take place in the
If you select Off, no automatic recording takes place.
CAUTION!
You can specify limitations for overwriting older recordings in Continuous mode by configuring the retention time (see Section 7.35 Retention Time, page 94).
Standard profile
From this field, you can select the encoder profile to be used for recording (see
Section 7.19 Encoder Profile, page 80).
NOTICE!
The recording profile can deviate from the standard setting Active profile and is only used during an active recording.
Pre-alarm Time
You can select the required
Post-alarm Time
You can select the required
Post-alarm profile
You can select the encoder profile to be used for recording during the
The Standard profile option adopts the selection at the top of the page.
Alarm input / Motion alarm / Video loss alarm
Here you can select the alarm sensor that is to trigger a recording.
Virtual alarm
Here you can select the virtual alarm sensors that are to trigger a recording, via RCP+ commands or alarm scripts, for example.
NOTICE!
For more information, please see the Alarm Task Script Language document and the RCP+ documentation. These documents can be found on the product CD supplied.
Recording includes
You can specify whether, in addition to video data and metadata (for example alarms, VCA data and serial data) should also be recorded. Including metadata could make subsequent searches of recordings easier but it requires additional memory capacity.
CAUTION!
Without metadata, it is not possible to include video content analysis in recordings.
Bosch Security Systems, Inc. | Installation Manual | F.01U.273.797 5.0 2012.08 |