AutoDome 800 Series HD PTZ CameraConfiguring the AutoDome 800 Series en 73
– HD low bandwidth Target bit rate: 2500 kbps Maximum bit rate: 5000 kbps Encoding interval: 30.00 ips
– SD high quality / low latency Target bit rate: 2000 kbps Maximum bit rate: 4000 kbps Encoding interval: 30.00 ips
– SD high quality
Target bit rate: 1500 kbps
Maximum bit rate: 3000 kbps
Encoding interval: 30.00 ips
– SD low bandwidth Target bit rate: 700 kbps Maximum bit rate: 1500 kbps Encoding interval: 30.00 ips
– DSL
Target bit rate: 400 kbps
Maximum bit rate: 500 kbps
Encoding interval: 30.00 ips
– ISDN (2B)
Target bit rate: 80 kbps
Maximum bit rate: 100 kbps
Encoding interval: 30.00 ips
7.5 | Basic Mode: Audio |
| You can set the gain of the audio signals to suit your specific requirements. The current video |
| image is shown in the small window next to the slide controls to help you check the audio |
| source and improve assignments. Your changes are effective immediately. |
| If you connect via Web browser, you must activate the audio transmission on the Livepagee |
| Functions page (see Section 6.6 The Livepage, page 61). For other connections, the |
| transmission depends on the audio settings of the respective system. |
| Audio |
| The audio signals are sent in a separate data stream parallel to the video data, and so increase |
| the network load. The audio data are encoded according to G.711 and require an additional |
| bandwidth of approx. 80 kbps for each connection. If you do not want any audio data to be |
| transmitted, select Off. |
| Line In |
| You can set the line input gain. Make sure that the display does not go beyond the green zone |
| during modulation. |
7.6Basic Mode: Recording
You can record the images from the AutoDome 800 Series on various local storage media or on an appropriately configured iSCSI system.
Here you can select a storage medium and immediately start the recording.
Bosch Security Systems, Inc. | Installation Manual | F.01U.273.797 5.0 2012.08 |
