Bosch Appliances VG5 800 SERIES Pre-installation Checklist, Description, Tools Required

AutoDome 800 Series HD PTZ CameraInstalling the Pendant Arm Wall, Corner, and Mast (Pole) Mounts en 15

2.1.2	Description
	This chapter details how to install an AutoDome Pendant Arm to a wall, a corner, or to a mast
	(pole). Any variations to the installation procedures are noted.
	See Section 3 Installing Roof Parapet and Pipe Mounts, page 33 for a Roof (Parapet) or Pipe
	mount installation.

2.1.3	Tools Required
	– 5 mm Allen wrench (supplied)
	– Small, straight-blade screwdriver - 2.5 mm (0.1 in.)
	– No. 2 Phillips screwdriver
	– Socket wrench and 9/16-in. socket
	– Banding tool (Bosch P/N TC9311PM3T) - if installing a mast (pole) mount
	– 3/4 in. (20-mm) NPS right angle conduit connector - if installing a mast (pole) mount with
	a VG4-ARMPLATE

2.2	Pre-installation Checklist
	1.	Determine the location and distance for the Power Supply Box based on its voltage and
		current consumption.
		You may choose to route the main power supply through an intermediate power supply
		box (VG4-PSU1 or VG4-PSU2) before connecting the power to the pendant arm power
		supply box (VG4-PA0). See Section 4 Cable and Wire Standards, page 51, for wiring
		information and distances.
	2.	Use only UL listed liquid tight strain reliefs for conduits to the Power Supply Box to
		ensure that water cannot enter the box. You must use water tight conduits and fittings to
		meet NEMA 4 standards.

WARNING!

Power and I/O cabling must be routed separately inside different permanently earthed metal conduits.

3.Route all rough wiring including: power, Ethernet, alarms I/O, relay I/O, and fiber optic cabling. See Section 4 Cable and Wire Standards, page 51, for video and control protocol methods.

WARNING!

Install external interconnecting cables in accordance to NEC, ANSI/NFPA70 (for US application) and Canadian Electrical Code, Part I, CSA C22.1 (for CAN application) and in accordance to local country codes for all other countries.

Branch circuit protection incorporating a 20 A, 2-pole Listed Circuit Breaker or Branch Rated Fuses are required as part of the building installation. A readily accessible 2-pole disconnect device with a contact separation of at least 3 mm must be incorporated.

4.Choose the appropriate AutoDome model for the environment in which it will be used.

5.Choose the appropriate mounting kit to use, depending on the location of the AutoDome, either wall mount, corner mount, or mast (pole) mount.

If the kit contains a Power Supply Box, refer to Section 2.3 Mount Power Supply Box, page 16.

If you are using the Mounting Plate with a 24 V AutoDome, refer to Section 2.8 Installing the VG4-A-ARMPLATE, page 26.

Bosch Security Systems, Inc. Installation Manual F.01U.273.797 5.0 2012.08