
AutoDome 800 Series HD PTZ CameraUsing the AutoDome 800 Series en 59
6.4.1 | Changing the Network Settings | |
| The AutoDome 800 Series has a default IP address of 192.168.0.1. To change the IP address | |
| or any network settings, you can use the Configuration Manager software or the AutoDome | |
| 800 Series server. | |
|
| |
| NOTICE! | |
| Contact your local network administrator for a valid IP address, Subnet Mask, and a Gateway | |
| IP Address. | |
|
| |
| Using the Configuration Manager | |
| Configuration Manager is an optional network utility provided on the Bosch Security Systems | |
| Web site. Use the Configuration Manager Manual to make any configuration changes. | |
|
| |
| NOTICE! | |
| Depending on the PC network security settings, the user may have to add the new IP address | |
| to the browser’s trusted sites list for the IP AutoDome controls to operate. | |
|
| |
| Using the AutoDome 800 Series Web Server | |
| To configure the camera using the AutoDome 800 Series server, do the following: | |
| 1. | Set the IP address on the PC to 192.168.0.10 to ensure that the PC and the AutoDome |
|
| 800 Series are on the same Subnet. |
| 2. | Launch Microsoft Internet Explorer and navigate to the following URL: http://192.168.0.1 |
|
| The Web browser opens the Livepage for the AutoDome 800 Series; a security warning |
|
| message is displayed. |
| 3. | Check the Always Trust box, then click YES. |
| 4. | Click the Settings link, located at the top of the Livepage. |
| 5. | Click the Service Settings link, located in the left pane of the Settings window. |
| 6. | Click the Network link to open the Network Settings page. |
Figure 6.2 Network Settings Page
7.Configure the settings on this page based on the addresses provided by your local network administrator.
Bosch Security Systems, Inc. | Installation Manual | F.01U.273.797 5.0 2012.08 |