Cisco Systems Cisco CRS-1 manual Physical Layer Interface Module Plim

Chapter 4 Installing and Removing SFCs, RPs, MSCs, PLIMs, and Associated Components

How to Install or Remove a Physical Layer Interface Module

Figure 4-26 Physical Layer Interface Module (PLIM)

1158460

You can install a PLIM in any of the four center slots in the front of the chassis (see Figure 4-17).

Caution The system may indicate a hardware failure if you do not follow proper procedures. Remove or install only one PLIM at a time. Allow at least 15 seconds for the system to complete the preceding tasks before removing or installing another PLIM.

	Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
4-42	OL-10971-07