Cisco Systems Cisco CRS-1 manual Removing a Bale-Clasp SFP Module

Chapter 4 Installing and Removing SFCs, RPs, MSCs, PLIMs, and Associated Components

How to Install or Remove a Small Form-Factor Pluggable (SFP) Module

Figure 4-33 Installing a Bale-Clasp SFP Module into a Port

116294

Removing a Bale-Clasp SFP Module

This section describes how to remove a bale-clasp SFP module. The module has a clasp used to install and remove the module (see Figure 4-34).

Figure 4-34 Bale-Clasp SFP Module

63067

Prerequisites

Before removing a module, disconnect any connected interface cables.

	Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
4-54	OL-10971-07