Chapter 4 Installing and Removing SFCs, RPs, MSCs, PLIMs, and Associated Components

How to Install or Remove a Physical Layer Interface Module

Figure 4-27

Installing a PLIM

1

2

3 158461

1

2

Captive screw

3 Direction of installation or removal

Ejector lever

Step 7 Orient the PLIM so that the status display is on top, then position the card for insertion into the card cage slot. Avoid touching the card circuitry or any connectors.

Note There are alignment grooves on each slot in the card cage. When you install a card, make sure that you align both the top and bottom edges of the card carrier in the slot grooves.

Step 8 Grasp both card ejector levers simultaneously, then push them both outward until they are fully extended in the open position.

 

Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide

4-44

OL-10971-07

Page 114
Image 114
Cisco Systems Cisco CRS-1 manual Installing a Plim