
Chapter 2 Installing and Removing Power Components
Installing a DC Power Shelf
Prerequisites
Bring down the power to the Cisco
Tip We recommend that you do this procedure with the line card chassis mounted in a rack with sufficient space for bottom and side access to the screws.
Required Tools and Equipment
You need the following tools and parts to perform this task:
•
•Medium
•Number 1 Phillips screwdriver
•Medium Phillips screwdriver
•5 mm Allen wrench
•10 mm hex socket wrench
•DC power input shelf (Cisco product number:
•DC power input module (PIM) (Cisco product number:
•DC power supplies (Cisco product number:
Note This procedure assumes that the Cisco
Steps
To install the DC power shelf, follow these steps:
Step 1 Attach the
Step 2 If the AC power shelf is currently installed, remove it from the front of the chassis. (For details, see the “Removing an AC Power Shelf” section on page
Removing the Rear Power Access Panels
Before you can install the power input module, you must remove the rear power access panels.
Step 3 From the rear of the chassis, use a medium Phillips screwdriver to remove the rear power access panels (located on the bottom right and bottom left rear of the chassis). Remove the screws shown in Figure
Tip One screw on each side is located under the chassis (as indicated in Figure
| Cisco |