
Chapter 4 Installing and Removing SFCs, RPs, MSCs, PLIMs, and Associated Components
How to Remove or Install a Card
Prerequisites
Before performing this task, open the doors if they are installed and ensure that the slot in which you are about to install the impedance carrier is empty. Depending on the slot in which you are installing an impedance carrier, see the “Removing an MSC” section on page
Required Tools and Equipment
You need the following tools and part to perform this task:
•
•Large Phillips screwdriver
•Impedance carrier
–SFC impedance carrier (Cisco product number:
–MSC impedance carrier (Cisco product number:
–PLIM impedance carrier (Cisco product number:
–RP impedance carrier (Cisco product number:
Steps
To install an impedance carrier, follow these steps:
Step 1 Attach the
Step 2 Use both hands while inserting an impedance carrier. Use one hand on the faceplate and the other hand along the base of the impedance carrier to guide it into a slot.
Step 3 Slide the impedance carrier into the chassis until the captive screw plates are flush with the chassis.
Step 4 Partially tighten the two captive screws on the front panel of the impedance carrier (either by hand or with the screwdriver) to make sure that they are both engaged.
Step 5 Use the screwdriver to fully tighten the captive screws to seat the impedance carrier firmly in the slot.
How to Remove or Install a Card Slide-Assistance Arm (Handle)
This section contains the following procedures:
•Removing a Card
•Installing a Card
All MSCs, PLIMs, and RPs are shipped with
|
| Cisco |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
|