Cisco Systems Cisco CRS-1 manual Installing a Bale-Clasp SFP Module

Chapter 4 Installing and Removing SFCs, RPs, MSCs, PLIMs, and Associated Components

How to Install or Remove a Small Form-Factor Pluggable (SFP) Module

Installing a Bale-Clasp SFP Module

This section describes how to install a bale-clasp SFP module. The module has a clasp used to install and remove the module (see Figure 4-32).

Figure 4-32 Bale-Clasp SFP Module

63067

Prerequisites

Before installing a module, remove any front cover plates.

Required Tools and Equipment

You need the following tools and part to perform this task:

•ESD-preventive wrist strap

•Bale-clasp SFP module

Steps

To install a bale-clasp SFP module (into a PLIM), follow these steps:

Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.

Step 2 Close the bale clasp before inserting the module.

Step 3 Align the module with the port and slide it into the port (see Figure 4-33).

Note Be careful to hold the module in such a way so as to not damage the bale clasp.

	Cisco CRS-1 Carrier Routing System 4-Slot Line Card Chassis Installation Guide
OL-10971-07		4-53