Compaq EV67, 21264 specifications 18Initialization and Configuration

Reset State Machine

Table 7–11 21264/EV67 Reset State Machine State Descriptions (Continued)

State Name	Description
RAMP2	Triggered by the duration counter reaching 4108 cycles, the Xdiv and Zdiv divisors are
	changed to 1 and 2, respectively, and the frequency is increased. The duration counter is
	reloaded to count 8205-cycles.
WAIT_ClkFwdRst0	Triggered by the duration counter reaching 8205 cycles (or by the deassertion of
	Reset_L while in the WAIT_RESET state). 21264/EV67 asserts SromOE_L and waits
	for SYSTEM to deassert ClkFwdReset_H. The deassertion must be synchronous to a
	falling edge of FrameClk_H. 21264/EV67 uses this deassertion to begin BiST and
	SROM load at a predictable time. 21264/EV67 samples and generates an internal,
	aligned copy of FrameClk_H, and, in turn, uses this clock to sample ClkFwdReset_H.
WAIT_BiST	BiST and SROM load is started. The SROM first loads the Write-once chain and then
	reads the number of bits of Icache data to load.
WAIT_BiSI	This state is entered when ’waking up’ from sleep mode. 21264/EV67 receives an exter-
	nal interrupt, ramps the PLL, synchronously samples a transition on ClkFwdReset_H,
	and runs built-in self-initialization to clear the internal caches. Built-in self-test is not
	performed and the SROM is not loaded.
WAIT_ClkFwdRst1	Entered when the appropriate amount of BiST and SROM loading has been completed.
	21264/EV67 deasserts SromOE_L and waits for SYSTEM to deassert
	ClkFwdReset_H. The deassertion must be synchronous to a rising edge of
	FrameClk_H. 21264/EV67 uses this synchronous event to reset the clock forwarding
	interface and deassert internal reset. 21264/EV67 subsequently begins running code
	(either preloaded in the SROM or located in memory) and begins system transactions.
RUN	Chip is running software, interface is reset, and system transactions can be processed.
	From power-up, the Icache sets are enabled and contain bootstrap code loaded from the
	SROM; 21264/EV67 executes code from Icache. From wake-up, the Icache sets are dis-
	abled and 21264/EV67 fetches and executes code from DRAM.
WAIT_RESET	Triggered by duration counter reaching 264 cycles, or when Reset_L is asserted when in
	WAIT_INTERRUPT state. 21264/EV67 waits in this state until Reset_L is deasserted,
	at which point, the PLL starts to ramp up again.
FAULT_RESET	ClkFwdReset is asserted while the 21264/EV67 is running. The 21264/EV67 internally
	resets a minimum amount of internal state, waits for clock forward reset deassertion, and
	begins fetching code at PAL_BASE + 0x780.
DOWN1	21264/EV67 was in a state in which GCLK was at its highest speed and Reset_L was
	asserted. Internal chip functions are reset and the internal duration counter is set to 8205
	cycles. The purpose of this sequence is to down-ramp the clocks in anticipation of power
	being removed. If power is not removed (that is, reset is being toggled), 21264/EV67
	ramps the clocks back to the original speed.
	This state is also entered when software writes the I_CTL internal processor register to
	sleep mode.

7–18Initialization and Configuration Alpha 21264/EV67 Hardware Reference Manual