Compaq EV67, 21264 specifications 4PALcode Restrictions and Guidelines

Restriction 1 : Reset Sequence Required by Retire Logic and Mapper

**or the PALcode, but it must be done in the manner and order below.

**It assumes that the retirator has been initialized, that the

**non-shadow registers are mapped, and that mapper source enables are on.

**Source enables are on. For fault-reset and wake from sleep, we need to

**ensure we are in the icache so we don’t fetch junk that touches the

**shadow sources before we write the destinations. For normal reset,

**we are already in the icache. However, so this macro is useful for

**all cases, force the code into the icache before doing the mapping.

**

**Assume for fault-reset, and wake from sleep case, the exc_addr is

**stored in r1.

*/
addq	r31,r31,r0	/* nop*/
addq	r31,r31,r0	/* nop*/
addq	r31,r31,r0	/* nop*/
br	r31, tch0	/* fetch in next block*/
.align	3
nxt0: lda	r0,0x0086(r31)	/* load I_CTL.....*/
mtpr	r0,EV6__I_CTL	/* .....SDE=2, IC_EN=3 (SCRBRD=4)*/
br	r31, nxt1	/* continue executing in next block*/
tch0: br	r31, tch1	/* fetch in next block*/
nxt1: mtpr r31,EV6__IER_CM		/* clear IER_CM (SCRBRD=4) creates a map-stall
		under the above mtpr to SCRBRD=4*/
addq	r31,r31,r0	/* nop*/
br	r31, nxt2	/* continue executing in next block*/
tch1: br	r31, tch2	/* fetch in next block*/
nxt2: addq	r31,r31,r0	/* 1st buffer fetch block for above map-
		stall*/
addq	r31,r31,r0	/* nop*/
br	r31, nxt3	/* continue executing in next block*/
tch2: br	r31, tch3	/* fetch in next block*/
nxt3: addq	r31,r31,r0	/* 2nd buffer fetch block for above map-stall*/
addq	r31,r31,r0	/* nop*/
br	r31, nxt4	/* continue executing in next block*/
tch3: br	r31, tch4	/* fetch in next block*/
nxt4: addq	r31,r31,r0	/* need 3rd buffer fetch block to get correct
		SDE bit for next fetch block*/
addq	r31,r31,r0	/* nop*/
br	r31, nxt5	/* continue executing in next block*/
tch4: br	r31, tch5	/* fetch in next block*/
nxt5: addq	r31,r31,r4	/* initialize Shadow Reg. 0*/
addq	r31,r31,r5	/* initialize Shadow Reg. 1*/
br	r31, nxt6	/* continue executing in next block*/
tch5: br	r31, tch6	/* fetch in next block*/
nxt6: addq	r31,r31,r6	/* initialize Shadow Reg. 2*/
addq	r31,r31,r7	/* initialize Shadow Reg. 3*/
br	r31, nxt7	/* continue executing in next block*/
tch6: br	r31, tch7	/* fetch in next block*/
nxt7: addq	r31,r31,r20	/* initialize Shadow Reg. 4*/

D–4PALcode Restrictions and Guidelines Alpha 21264/EV67 Hardware Reference Manual