Delta Electronics VFD-M manual Parameter, Explanation, Settings, Factory

		Chapter 4 Parameters
Parameter	Explanation	Settings	Factory	Customer
			Setting
		00: Disable PLC operation
		01: Execute one program cycle
Pr.78	PLC Operation Mode	02: Continuously execute program cycles	00
		03: Execute one program cycle step by step
		04: Continuously execute one program cycle
		step by step
Pr.79	PLC FWD/REV	00 to 127	00
	Motion
Pr.80	Identity Code of the	Read only	##
	AC Motor Drive
Pr.81	Time Duration of 1st	00 to 9999 sec	00
	Step Speed
Pr.82	Time Duration of 2nd	00 to 9999 sec	00
	Step Speed
Pr.83	Time Duration of 3rd	00 to 9999 sec	00
	Step Speed
Pr.84	Time Duration of 4th	00 to 9999 sec	00
	Step Speed
Pr.85	Time Duration of 5th	00 to 9999 sec	00
	Step Speed
Pr.86	Time Duration of 6th	00 to 9999 sec	00
	Step Speed
Pr.87	Time Duration of 7th	00 to 9999 sec	00
	Step Speed
Pr.88	Communication	01 to 254	01
	Address
		00: 4800 bps
Pr.89	Transmission Speed	01: 9600 bps	01
		02: 19200 bps
		03: 38400 bps
		00: Warn and Continue Operating
Pr.90	Transmission Fault	01: Warn and RAMP to Stop	03
	Treatment	02: Warn and COAST to Stop
		03: Keep Operation without Warning
Pr.91	Time Out Detection	0.0: Disable	0.0
		0.1 to 120.0 sec
		00: MODBUS ASCII mode, <7,N,2>
		01: MODBUS ASCII mode, <7,E,1>
Pr.92	Communication	02: MODBUS ASCII mode, <7,O,1>	00
	Protocol	03: MODBUS RTU mode, <8,N,2>
		04: MODBUS RTU mode, <8,E,1>
		05: MODBUS RTU mode, <8,O,1>

Revision May 2008, ME14, SW V3.04 4-9