Emerson Rosemount 8732 manual Index Parameter Description, Diagnosis

Rosemount 8732

Reference Manual

00809-0100-4665, Rev AA August 2010

Index	Parameter	Description
26	DEVICE_MAN_ID	Mapped to Mfg_ID parameter in
		Manufacturing Block
27	DEVICE_ID	Mapped to DEV_TYPE parameter in
		Manufacturing Block
28	DEVICE_SER_NUM	Mapped to last 16 characters of
		DEVICE_ID_STRING parameter in
		Manufacturing Block
29	DIAGNOSIS	Detailed information of the device, bitwize
		coded. More than one message is possible at
		once. If MSB of byte 4 is set to 1 than more
		diagnostic information is available in the
		DIAGNOSIS_EXTENSION parameter.
30	DIAGNOSIS_EXTENSION	Additional manufacturer-specific information
		of the device, bitwize coded. More than one
		message is possible at once.
31	DIAGNOSIS_MASK	Supported std diagnostics
		Warmstart
		Coldstart
		maint requd
		ident number violation
		function check
		failed
		maint demanded
		extension available
32	DIAGNOSIS_MASK_EXTENSION	Definition of supported
		DIAGNOSIS_EXTENSION information-bits.
33	RESERVED
34	WRITE_LOCKING	Software write protection.
		0: acyclic write service of all parameter are
		refused, except
		WRITE_LOCKING and the TAB_ENTRY
		parameter of the Linearization table, i.e.
		access is denied.
		2457: is the default value and means all
		writable parameters of a device are writable.
35	FACTORY_RESET	1: (mandatory) is the command for resetting
		device for default values. The setting of the
		bus address is not affected.
		2506: (optional) is the command for warmstart
		of the device. All parametrisation remains
		unchanged.
		2712: (optional) The bus address to its default
		address; other parametrisation remains
		unchanged. The bus address is changed
		immediately regardless if the
		device is in cyclic data transfer state. The
		reset is not suspended up to a subsequent
		power cycle/warmstart.
36	DESCRIPTOR	User-definable text (a string) to describe the
		device within the application.
37	DEVICE_MESSAGE	User-definable MESSAGE (a string) to
		describe the device within the application or
		in the plant.
38	DEVICE_INSTALL_DATE	Date of installation of the device.
39	LOCAL_OP_ENA	Local operation enable.
		0: disabled (Local operation not allowed, i.e.
		change of FB MODE from host
		device only)
		1: enabled (Local operation is allowed).

F-2