Fostex VR800 Setting digital output tracks Digi. Out ? menu, Setting a clock of digital, 102

VR800 Owner’s Manual (Changing the initial setting: SETUP mode)

Setting a clock of digital in

1.While the digital input track setting ([AdAt], [*L], or [r*]) is flashing, press the HOLD/> key, REW button,

or F FWD button so that [A SYnC] will flash.

The “ ” indicator will also flash.

2. Turn the JOG dial to select [ASYnC] or [SYnC].

In [A SYnC] mode, the system does not synchronize the digital-in clock. In [SYnC] mode, the system synchronizes the digital-in clock.

3. After you select the clock, press the EXECUTE/YES

DIGITAL 44.1kHz

key.

flashes

SYNC OUT	DRIVE
CLK	SCSI
AUTO	A.PUNCH

The selected clock will be registered, and the display shown in step 2 appears.

Note: Set the digital-in clock and the digital mixer clock carefully if the VR800 is connected to a digital mixer. Refer to “Connecting a digital mixer” in the Quick Operation Guide.

Setting digital output tracks (“Digi. Out ?” menu)

The “Setting digital output tracks” menu enables you to assign the track that outputs digital signals from the DATA OUT connector of the VR800 to an external digital device. You can send the recorded audio data on the VR800 to an external digital device (MD, DAT, adat, digital mixer, etc.) in digital form. Any two tracks selected from tracks [1]–[8] are assignable. You can also select [AdAt] to output all track data (1–8) simultaneously to a digital device with an adat input.

• Initial setting :AdAt

•Assignable tracks: L channel = [AdAt], [1] ~ [8] R channel = [1] ~ [8]

*This setting is shared by all Programs in the same disk.

*The settings cannot be saved and loaded as part of the song data.

*The settings are maintained after you turn off the power to the unit.

<IMPORTANT>

Match the sampling rate of the digital input on the external device with the sampling rate of the VR800 to send digital signals from the VR800 to the external device.

Setting digital output tracks

1.While the VR800 is stopped, press the SETUP key to enter SETUP mode.

2.Turn the JOG dial to select [Digi. out ?] ([?] flashes),

then press the EXECUTE/YES key.

The current digital output track assignment appears on the display.

Pressing the EXECUTE/YES key turns off the flashing [?] character, and setting of the digital output track flashes. With the initial setting, [AdAt] flashes as shown below. You can select a flashing channel to assign a track.

DIGITAL	44.1kHz
		flashes
SYNC OUT	DRIVE
CLK	SCSI
AUTO	A.PUNCH
	44.1kHz
DIGITAL
		flashes
SYNC OUT	DRIVE
CLK	SCSI
AUTO	A.PUNCH

3. While the [AdAt] is flashing, turn the JOG dial.

When you turn the JOG dial, the flashing [AdAt] indicator changes to the S/P DIF digital output track indication.

102