Fostex VR800 owner manual Executing Track Exchange

	VR800 Owner’s Manual (Editing Tracks)
Executing Track Exchange
	• Swapping mono track data between any two tracks
	1. When [1-8] is flashing, turn the JOG dial.
1. While the VR800 is stopped, press the EDIT key

repeatedly until [TRK Exchg] flashes on the display.			Turning the JOG dial allows you to select a mono
Alternatively, you can press the EDIT key, then use the			track from [1], [2], [3], [4]........ [24] in the left column.
JOG dial.			The right column continues a mono track.
			For example, if you select [4] in the left column, the
Flashing	DIGITAL	44.1kHz	display indicates [4<>1], meaning you can swap data
			between tracks 4 and 1.
			Flashing	DIGITAL	44.1kHz
	SYNC OUT	DRIVE
	CLK	SCSI
	AUTO	A.PUNCH

SYNC OUT	DRIVE
CLK		SCSI
AUTO	A.PUNCH

2. Press the EXECUTE/YES key.

The display shows the track selection.
The current display shows that you can swap eight-track			Flashing	DIGITAL	44.1kHz
data between Real tracks 1-8 and Additional tracks 9-16.
If you wish to select other tracks, follow the steps below.
				SYNC OUT	DRIVE
Flashing	DIGITAL	44.1kHz		CLK	SCSI
				AUTO	A.PUNCH

				2. To select a number in the right column, press
		SYNC OUT	DRIVE
		CLK	SCSI	the HOLD/> key, the REWIND button, or the F
		AUTO	A.PUNCH
				FWD button to move the flashing cursor to the
				right column, then use the JOG dial to select
3. Select the tracks to swap data.				the desired number.
				* When you swap data between mono tracks, the
	• Selecting Real tracks 1-8 and Additional tracks 17-24:			indications [4<>1] and [1<>4], for example, mean the
				same thing — swapping data between tracks 1 and 4.

1. Press the HOLD/> key, the REWIND button, or
the F FWD button to move a flashing cursor on			Note: If you select the same tracks for swapping mono
[1-8] (left) to [9-16](right).
			track data, the setting is ignored. The VR800 will indicate
DIGITAL	44.1kHz	Flashing	[Select Err] for a short moment, then return to the previous
			display.

		4. Press the EXECUTE/YES key.
SYNC OUT	DRIVE
CLK	SCSI
		[Exchange] lights up and the swapping operation is
AUTO	A.PUNCH
		completed immediately.

2. Turn the JOG dial to change flashing [9-16] to			The VR800 indicates [COMPLETED !], then returns to the
			previous Time Base display.
flashing [17-24].
			Data on the additional tracks, as it stands, cannot be played
DIGITAL	44.1kHz	Flashing	back or its REC END confirmed. To do this, the data must
			be temporarily moved to a real track.
			If the additional track data, which is longer than the real
SYNC OUT	DRIVE		track (1~8) data is to be saved to DAT or adat, the longer
AUTO	A.PUNCH
CLK	SCSI
			time data must be replaced to the real track. Please refer to
			“Save/load” for details.

67