Fostex VR800 owner manual Modifying or deleting stored time signatures

VR800 Owner’s Manual (Changing the initial setting: SETUP mode)

To cancel the setting operation, or to exit SETUP mode after storing data, press the STOP button or the EXIT/ NO key. Each time you press one of these keys, the VR800 returns to the previous hierarchy level of the menu, and finally exits SETUP mode.

Modifying (or deleting) stored time signatures

1.Repeat steps 1-3 described in the “Storing a time signature” section to display [Sign. Edit].

2.Press the HOLD/> key, the REWIND button, or the F FWD button so that the flashing cursor is on the time signature value.

3.Use the JOG dial to enter a new value.

Entering [—] deletes the existing data.

Note that you cannot enter [—] for measure 001.

Caution: If modifying or deleting the stored time signature causes the bar/beat setting for the tempo specified in the “Setting a tempo” menu to disappear, the tempo setting will also be automatically erased.

To cancel the setting operation, or to exit SETUP mode after storing data, press the STOP button or the EXIT/NO key. Each time you press one of these keys, the VR800 returns to the previous hierarchy level of the menu, and finally exits SETUP mode.

4. Press the EXECUTE/YES key.

Clearing all time signature and tempo settings

Caution: Using this function will erase not only the time signature setting but also the tempo data specified in the “Setting a tempo” menu described in the next section.

To cancel the All Clear operation, press the STOP button or the EXIT/NO key now. Each time you press one of these keys, the VR800 returns to the previous hierarchy level of the menu, and finally exits SETUP mode.

1.Repeat steps 1-3 described in the “Storing a time signature” section to display [Sign. Edit].

2.While the measure number is flashing, turn the JOG

dial counter-clockwise to select [All Clear ?].

When [All Clear ?] appears, [SURE ?] flashes, and you can clear the time signature and tempo data in the next step.

DIGITAL44.1kHz

SETUP

SURE ?			flashes
SYNC OUT	DRIVE
CLK		SCSI
AUTO	A.PUNCH

3. Press the EXECUTE/YES key.

The stored time signature and tempo data in its entirety are cleared, and the initial settings are restored.

Changing the BAR at ABS “0” of the time base

BAR in -002BAR/1 /00CLK, which indicates the head figure of the disk in the time base BAR/BEAT/CLK, can be changed. Although the initial figure is -002BAR, this can be set within the range of -009BAR ~ -002BAR.

1.Repeat steps 1-2 described in the “Storing a time signature” section to display [Sign. Chk].

2.Turn the JOG dial counter-clockwise to select [-002

BAR OFFSET].

When the JOG dial is rotated to extreme left [-002BAR OFFSET], as shown below will appear (-002BAR is the initial setup figure).

DIGITAL44.1kHz

SETUP

BAR

SYNC OUT	DRIVE
CLK	SCSI
AUTO	A.PUNCH

3.Press the EXECUTE/YES key.

[2]in [-002BAR] will flash and the bar figure can be changed with the JOG dial (Numbers that can be input are 2~9.)

DIGITAL44.1kHz

SETUP

BAR

flashes

SYNC OUT	DRIVE
CLK	SCSI
AUTO	A.PUNCH

4.Use the JOG dial to enter a new value.

5.Press the EXECUTE/YES key.

91