VR800 Owner’s Manual (Saving and Loading Song Data)
<Quick Troubleshooting>
If you are stuck in one of the following situations, refer to the explanations below for corrective actions.
#The VR800 displays the following during the save operation using a SCSI backup drive:
Flashing
DIGITAL44.1kHz
SETUP
SURE ?
SYNC OUT |
| DRIVE |
CLK | IDE | |
|
|
|
AUTO |
| A.PUNCH |
The backup disk contains some data and does not have enough free space to record new data. The VR800 is asking you whether or not the existing data should be deleted. Take one of the following actions:
* If you wish to delete the existing data:
Press the EXECUTE/YES key twice. Pressing the key once causes [Del. ALL ?] and [SURE ?] to flash, and pressing it again deletes the existing data so that you will be able to continue the save operation.
* If you do not wish to delete the existing data:
Turn the JOG dial to display [Eject], then press the EX- ECUTE/YES key. The disk will be ejected. Insert another backup disk in the drive.
#When you inserted a SCSI backup disk into the backup drive to save data, the following messages appeared in turn and the disk was ejected.
DIGITAL44.1kHz
SETUP
SYNC OUT |
| DRIVE |
CLK | IDE | |
|
|
|
AUTO |
| A.PUNCH |
DIGITAL44.1kHz
SETUP
The VR800 recognizes that the backup disk cannot be used in its current condition. There are two reasons for this.
*You inserted a disk that was used for the current drive.
*The disk’s recording mode differs from that of the data to save or load.
For example, the disk used to save or load data in Master 8ch mode is inserted to save data in ADAC 8ch mode. That is, you tried to use a disk (that was once used to save or load data in a particular recording mode) to save data in a different recording mode.
Current drive |
|
|
|
|
|
| Backup drive |
|
|
| save |
| |||
|
|
|
| ||||
dsik in ADAC 8ch mode |
|
|
|
|
|
| data recorded inADAC 8ch |
|
|
|
|
|
| ||
|
|
|
|
|
| mode | |
|
|
|
|
|
|
| |
|
|
| load |
| |||
Current drive |
|
|
|
|
|
| Backup drive |
|
|
| save |
| |||
|
|
| disk used to save/load data | ||||
disk in Master 8ch mode |
|
|
|
|
|
| |
|
|
|
|
|
| in ADAC 8ch mode | |
|
|
|
|
|
| ||
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
To be able to use the ejected disk, you need to
*Quit SETUP mode and return to the Time Base display of the current disk, then insert the disk in the backup drive.
*Select the [Bk Format ?] menu in SETUP mode and re- format the backup disk.
Note: When saving a multiple number of program data to one disk, they must be in the same format.
Should data of different format be mixed and saved, the situ- ation above will occur.
SYNC OUT
CLK
AUTO
DRIVE
IDE
A.PUNCH
DIGITAL44.1kHz
SETUP
SYNC OUT
CLK
AUTO
DRIVE
IDE
A.PUNCH
87
