
VR800 Owner’s Manual (Locate Function)
Auto Play
The Auto Play function allows the VR800 to start play back automatically from the located point. AUTO PLAY mode should be turned on before you execute the Direct Locate function described above.
Note: This function is effective within 24 ABS hours. Therefore, if playback continues over the recording end point, the VR800 will still continue counting the time. Also, when the VR800 locates ABS REC END, it will continue counting the time from the recording end point. (However, the VR800 does not access the disk after reaching the recording end point.)
<Example: Operation at locating to the AUTO PUNCH IN point.>
| AUTO PUNCH IN point |
| PLAYBACK |
LOCATE | LOCATE |
PLAYBACK | |
START |
|
LOCATE LOCATE
START
1.Press the AUTO RTN/AUTO PLAY key to turn on the [PLAY] indicator on the bottom of the display.
AUTO
Lights up |
| PLAY |
|
2. Press the LOCATE key, or memory key.
The VR800 locates the point and plays as shown in the diagram.
•You can set a preroll time in the [Preroll Time ?] menu in SETUP mode so that the VR800 will start playback preroll time before the locate point. You can set the preroll time from 0 to 10 seconds. Refer to the chapter “Changing the Initial Settings (SETUP Mode)” on page 94.
3.Press the STOP button to stop the VR800.
Auto Return
This function allows the VR800 to play data up to the AUTO RTN END point, then automatically locate the AUTO RTN START point as shown in the diagram below. To enable this function, AUTO RTN mode should be on and the AUTO RTN START point and AUTO RTN END point should already be set.
<Operation of the Auto Return mode.>
AUTO RTN START point | AUTO RTN END point |
PLAYBACK | PLAYBACK |
START | Automatic locating to the AUTO RTN START point |
| subsequent to playback to the AUTO RTN END point. |
| LOCATE |
| STOP |
1. Store the AUTO RTN START and AUTO RTN END points.
Refer to the chapter “Storing a Locate Point (Edit Point)” on page 48 for information on storing the desired points in the AUTO RTN START key and the AUTO RTN END key.
2.Press the AUTO RTN/AUTO PLAY key to turn on the [RTN] indicator on the bottom of the display.
AUTO
RTN |
| Lights up |
|
3. Start playback a little before the AUTO RTN END point.
The VR800 operates as shown in the diagram.
•You can set a preroll time in the [Preroll Time ?] menu in SETUP mode so that the VR800 will start playback preroll time before the locate point. You can set the preroll time from 0 to 10 seconds. Refer to the chapter “Changing the Initial Settings (SETUP Mode)” on page 94.
55